Electrician in Tarpon Springs, FL
Faulkner Electric is a family-owned electrical contractor, and Tarpon Springs is one of the towns we cover out of Spring Hill. Our Florida State Certified Electrical Contractor license, EC13006813, is a statewide license. Crossing from Pasco into Pinellas does not change who is allowed to do the work.
What the county line does change is almost everything around the work. Tarpon Springs was the first incorporated city in what is now Pinellas County. It sits where the Anclote River meets a ring of bayous, and a large share of its homes are either on the water or close enough to it that storm surge is part of the conversation. Most of what we do here comes back to water, and to how high your electrical equipment sits above it.
Pinellas permits, not Pasco permits
Inside city limits, electrical permits go through the City of Tarpon Springs Building Development department on East Pine Street. That is a different office from Pasco County, and different again from Pinellas County's own building department, which covers the unincorporated areas and a handful of smaller towns. Some homes with a Tarpon Springs mailing address sit outside the city, so we confirm which office has jurisdiction for your address before the job is scheduled, not halfway through it.
The city has also added a step for flood zones. Starting October 1, 2026, Tarpon Springs requires a separate floodplain permit for new construction and for additions to existing buildings in a designated flood zone. A service repair on its own is not an addition, but if your electrical work is part of a bigger renovation, that permit belongs in the plan from the first day.
Docks, lifts and the circuit at the end of the yard
A house on Kreamer Bayou, Whitcomb Bayou or one of the canals off the Anclote usually has electrical equipment a long way from the panel. A lift motor and its switch, dock lights, a shore power receptacle, sometimes a cleaning station with its own outlet. All of it lives outdoors, over brackish or salt water, and gets used by people standing on a wet deck in bare feet.
The feed out to the dock is the part we look at hardest. It is often the longest run on the property, it may cross a seawall, and on an older lot it was frequently added years after the house was built by whoever put in the lift. A motor that hums but will not turn, a ground-fault device that trips every time it rains, or lights that dim when the lift starts are all reasons to have that run tested. If anyone has ever felt a tingle from a ladder or a lift frame, keep people out of the water near that dock until it has been checked.
What a correct installation includes, from the breaker to the lift motor, is on our boat lift and dock wiring page.
How high your equipment sits now matters
Florida's building code has a specific rule for homes in flood zones. Panels, disconnects, air conditioning equipment and other service equipment are supposed to sit at or above the elevation the flood rules set for that lot. Wiring itself may run lower if it is rated and installed for wet locations, but the boxes that hold breakers and controls belong up out of the water.
Plenty of houses in Tarpon Springs were built before that rule existed, and that is allowed. It starts to matter when something gets replaced. The current code says exterior equipment replaced after flood damage has to meet the elevation requirement, and a large enough renovation can trigger the FEMA 50 percent rule, which pulls the whole structure under the floodplain regulations. A panel swap that looks routine can become a question of where the new panel is permitted to go.
We would rather settle that on paper than on the wall. If you are planning an electrical panel upgrade, the height of the new equipment is part of the plan from the start. The same thinking applies to an EV charger installation in a garage that sits low: we talk through mounting height and where the circuit runs before anything is drilled.
After the water goes down
Tarpon Springs has had two recent reminders of what surge does here. During Hurricane Idalia in 2023 the surge flooded streets in downtown Tarpon Springs, and during Hurricane Helene in 2024 several feet of seawater flowed into businesses along the Sponge Docks.
Getting power back after a flood is split in two. The utility owns the line to your meter. The meter base, the panel and every wire on your side of it are yours. After Helene, Duke Energy Florida told customers whose meter, breaker box or privately owned wiring was damaged to contact their local municipality for guidance, and noted that inspections may be required once repairs are done. In Tarpon Springs that means a licensed electrician assesses and repairs the house side, and the city's building department decides what gets inspected before the meter goes back on.
On a house that took water, we check everything the waterline reached: receptacles and switches low on the walls, the panel if it was below the line, the air conditioning disconnect, pool equipment and the dock feed. Some of it can be cleaned and tested. Breakers, ground-fault receptacles and anything with electronics inside that sat underwater are normally replaced rather than trusted.
Surge is the quieter storm problem. Lightning nearby and the switching that happens while crews bring a grid back up can both put spikes on the line, which is what our whole-home surge protection page is about. If a long outage is the bigger worry, a whole-home generator is an option here too, but on a low lot it raises the same height question as everything else. The generator and its transfer equipment need to sit where the next surge will not reach them.
Older homes around Spring Bayou
The historic district wraps around Spring Bayou, where the raised banks let winter residents of the town's resort years build large Victorian-era homes along the stretch still known as the Golden Crescent. The district reaches into downtown and the streets beyond it, and many of its older houses are wood frame buildings that have had several rounds of electrical work by different people over many decades.
In a house like that the question is rarely one outlet. It is what is in the walls, what has been abandoned in place, and whether newer circuits were spliced into older ones somewhere in the attic. A whole-house look is often the right first step, and our electrical wiring inspection page explains what that covers. Older homes also come with plaster, original trim and owners who would like both to survive the job, so we plan new wiring routes around them rather than through them.
Working with us
Call 727-842-4920. Tell us your street, whether the house is in a flood zone if you know, and what is going on. Our office hours are Monday through Friday, 9 AM to 4 PM, and after hours we take emergency calls. We will look at the house, tell you what we found and what your options are, and put it in writing. We are a Florida State Certified Electrical Contractor, license EC13006813, and we are insured. We do not quote prices online, because on a waterfront lot the answer depends on things we have to see in person, starting with where the equipment sits.
Faulkner Electric. A Spring Hill family business that is comfortable on a bayou lot in Tarpon Springs.
Questions we hear in Tarpon Springs
You are based in Spring Hill. Can you pull permits in Tarpon Springs?
Yes. Our license, EC13006813, is a Florida state certified license, which is valid in every jurisdiction in the state. Inside city limits the permit comes from the City of Tarpon Springs Building Development department, and we file it ourselves as part of the job.
Our boat lift hums but will not move. Is that an electrical problem?
Often it is. A motor that hums without turning usually points to low voltage at the motor, a failing switch, or a corroded connection somewhere along the run out to the dock. If anyone has felt a tingle on the lift frame or the ladder, keep people out of the water near that dock until it has been tested.
Our house is in a flood zone. Does a new panel have to be raised?
It can. Florida's building code expects electrical equipment in a flood zone to sit at or above the elevation set for the lot, and that applies when flood-damaged exterior equipment is replaced or when a project counts as a substantial improvement. Whether it applies to your panel depends on your zone, your elevation and the scope of the work, so we sort it out before the permit is filed.
Our house took water in a storm. Who decides when the power can come back on?
The utility reconnects the meter, but it does not inspect your wiring. After Hurricane Helene, Duke Energy Florida told customers with damaged meters, breaker boxes or private wiring to contact their local municipality and noted that inspections may be required after repairs. A licensed electrician evaluates and repairs the house side first, and in Tarpon Springs the city building department decides what has to be inspected.
Are you licensed and insured?
Yes. We are a Florida State Certified Electrical Contractor, license EC13006813, and we are insured. The license number is on every page of this site and on every document we hand you.



